1/ that mean after installed ffmpeg and check
still working, but after started bubbleserver, and go to http://mynasip:58050
then i saw the message:
Audio Transcoding supported: no (ffmpeg has no libmp3lame support)
Video Transcoding supported: no (ffmpeg has mp3 encoding support)
i installed ffmpeg by using
ipkg install ffmpeg
and compile by this guide http://bubblesoftapps.com/bubbleupnpserver/#faq7
Coz i want to use my ChromeCast and if ffmpeg dont work then all of my movies will mute.
2/ i followed to this intrustion : http://www.raspberrypi.org/forums/viewt ... 4&p=528057
unpack the archive in a directory
on unix platforms make launch.sh executable: chmod +x launch.sh
on unix platforms run launch.sh, on Windows run launch.bat. Java 1.6 must be installed and the "java" executable must be in your PATH
point your Web Browser to http://localhost:58050 to show the configuration interface
for Internet access with Android BubbleUPnP, configure your firewall / Router NAT to allow access to TCP port 58050 (see server configuration below)
And yes, if followed, the bubbleserver can start without output message, but bubbleserver will be stopped when i close putty command,
in this step i changed :
to the path where i extracted bubbleserver package
That all i did, now the bubbleserver started, no ffmpeg detected for transcoding, and when i closed putty command, bubbleserver shutdown too.
After manytime googled, tried and test, i cannot get this work normally, tried to ask the developer but they didnot reply.
All i want is someone give me an intrustion how to install bubbleserver can start at boot, ffmpeg support.
So please try help me to do this, sorry for my bad knowledge about linux.