First time here and need help.
I just bought used terastation ts-wxl/r1 without any HDD inside.
I own Linkstation and generally know the procedure with new hdd and nas
When I installed one hdd I had available at the moment and turned NAS on, it went into EM mode, navigator recognized it, and it showed also EM mode.
I downloaded 1.55 firmware and used updated, it did not went in normal mode, so tried forced update and immediately with start of formatting stooped and showed me acp_state_failure.
Tried different ip, connection trough router, and directly to pc, but nothing.
I also tried acp_commander.jar with clear boot command, and it showed that nas is responding, it even showed acp_state_ok message, but with funny firmware version 12.00 ?!
after this, I tried to update it agagin, and again, same thing.
As I read, it could mean hardware failure and the guy who sold me this nas screwed me, or something could be done.
I tried to update it from safe mode and got same message.
I am really stuck here and need some useful advice.
Thx in advance