Buffalo NAS-Central Forums

LS-QL/1D E22 error on 2 of 4 disks
Page 1 of 1

Author:  brendangeorge [ Fri Dec 19, 2014 3:00 pm ]
Post subject:  LS-QL/1D E22 error on 2 of 4 disks

I have a LS-QL/1D with 4X2TB drives f/w 1.1 configured as a RAID 5. It is in constant use running really well. It looked a little full so I cleaned out the trash and it is at 67% now - all good. I new look at the box - it just works. I noticed yesterday that disks 2 and 3 have orange lights and the power light is flashing 22. From NASNavigator2 it looks as if this started on 2014/09/19 - what does fails disk mount refer to? The gadget looks as if it is running ok and is on a UPS so no power issues.

The Web Interface shows no errors but NASNav does ?

Any ideas or thoughts would be great.

I think I'll sort out a backup in case my world goes to crap 8-)


Author:  oxygen8 [ Fri Dec 19, 2014 3:35 pm ]
Post subject:  Re: LS-QL/1D E22 error on 2 of 4 disks

check the SMART- Values of the drives

Author:  dsmithdewarcom [ Mon Dec 29, 2014 10:00 pm ]
Post subject:  Re: LS-QL/1D E22 error on 2 of 4 disks


The Status LED under the power switch on our LS-QL is blinking red/blue (drive lights are steady green), so I checked the web admin which shows all good except NTP check failed (probably due to some problems with a new DSL modem).

Out of curiosity, I downloaded this nasnavigator2 and, like yours it is showing no drives found. However I'm wondering if NN2 is not compatible with the LS-QL. The share is online and files/folders accessible so this report makes no sense. The properties tab in NN2 also incorrectly shows the LS-QL's ip as DHCP, but it is static (set in web admin).

What should I make of the blinking status LED (the manual is unclear on this)?

EDIT: After a reboot the Status LED is steady blue and NN2 is showing no errors

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited