The Samba build process is
to configure and then build Samba. This process can take a long time (5-8 hours).
The above works as described
You can then update Sambas 3 by using
This does, however, assume that you have run the Update_Samba3.sh script as this
does some additional setup work that is specific to TeraStations.
The above is confusing... What does the sentence after
say? Should I have the current 3.0.x Samba installed beforehand? Or...
The compressed archive is then produced by running command of the following form:
make prefix=/opt install
tar -czvf samba_archive.tgz *
Do I need to replace the existing samba3_xxx.tgz file with the one created above and run the ./Update_sambe3.sh script again?
All very confusing
The make install also throws some errors about a 'mt' command not found, not sure what that is.