Buffalo NAS-Central Forums
http://forum.buffalo.nas-central.org/

How to change network settings when no network access?
http://forum.buffalo.nas-central.org/viewtopic.php?f=40&t=44559
Page 1 of 1

Author:  K2teknik [ Mon Mar 12, 2018 9:03 am ]
Post subject:  How to change network settings when no network access?

I manage to change some network setting (try to add an extra IP address) and in that change I lost network contact to my device.
I can logon via the rs232 port, but I can't edit the files as I do not know the root password.

I take out the harddrives and via a IDE-2-USB converter I manage to get one drive (I only have one converter) at the time visible on a respberry Pi as /dev/sda1, but I cant mount the first partition because it is a part of a raid, and "mdadm --assemble /mnt /dev/sda1" gives "mdadm: no recogniseable superblock on /dev/sda1", and from here I am out of where to go.

Author:  oxygen8 [ Mon Mar 12, 2018 10:34 am ]
Post subject:  Re: How to change network settings when no network access?

Teranavigator can set a new ip-adress

Author:  K2teknik [ Fri Mar 16, 2018 8:39 pm ]
Post subject:  Re: How to change network settings when no network access?

oxygen8 wrote:
Teranavigator can set a new ip-adress
I did try that, even with 3 different version of Teranavigator, but non of them manage to find my Terastation.

Author:  oxygen8 [ Fri Mar 16, 2018 9:24 pm ]
Post subject:  Re: How to change network settings when no network access?

which firmware was running before the crash

Author:  K2teknik [ Sat Mar 17, 2018 1:18 pm ]
Post subject:  Re: How to change network settings when no network access?

oxygen8 wrote:
which firmware was running before the crash
Good question, I do not have the Terastation on hand, but I think it is stock fw, I do not recall I had modified it, I had open up for ssh.

On all my other Terastations I have modified fw but they are not based on the PowerPC platform.

Author:  oxygen8 [ Sat Mar 17, 2018 11:32 pm ]
Post subject:  Re: How to change network settings when no network access?

with the stock fw the nasnavigator is able to set a new ip-adress

Author:  K2teknik [ Sun Mar 18, 2018 9:36 am ]
Post subject:  Re: How to change network settings when no network access?

oxygen8 wrote:
with the stock fw the nasnavigator is able to set a new ip-adress
Maybe, but I had change a file in the network setup, that may prevent the nasnavigator from finding my Terastation?

Any hints of where to find a version of nasnavigator that for sure will work with a PowerPC version of Teraswtation?

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/