I have been using an LS220 Linkstation (1TB)for a few years (Using Win 7) and ran out of space so
I purchased new new compatible Toshiba hard drives (3TB each) same make and model as used
in the 1TB configuration. I decided to just replace the old drives rather then do a
replaced drive scenario. We used these drives for backup only so I did not need
to preserve the data.
I have transitioned to WIN 10 from WIN 7 and the linkstation performed as it should.
All went well as far configuring the drives and getting the
accounts setup until I ran the Navigator2 program.
It did not find the Linkstation!
I turned off the firewall as I recall having to do that with the old configuration but that made
What must I do to get this problem resolved?
What step am I missing?