Buffalo NAS-Central Forums

Welcome to the Linkstation Wiki community
It is currently Wed Dec 13, 2017 7:45 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Aug 04, 2017 11:42 am 
Offline
Total Newbie

Joined: Thu Aug 03, 2017 11:10 am
Posts: 1
After shutting down my Terrastation just a few days ago using the correct procedure I am was later faced with all four RED led lights blinking on the front panel
I tried shutting the NAS box down by the front power button but it would not respond, the only way I could get it to turn off to re-boot it was to disconnect the power cord.
It has now rebooted but I am unable to access it, the NASNavigator2 control panel shows no associated ip address and a red box at the bottom sating 'EM Mode' on passing the mouse cursor over the icon it says "The EM Mode was detected, Update Firmware or contact your local technical support.

Also when I try to set an ip address I get a pop-up box with Chinese writing which is undecipherable and a single option to select OK, I can ping the box OK but that is about it.

Anyone able to shed any light on this issue please.

Peter


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 15 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Powered by phpBB® Forum Software © phpBB Limited