yes i used the openocd source package from the downloadsection...which one did you use davygravy?
i will compile it from svn as well bbradley...
I use svn 335 w/ the patch that is shown in the article - works pretty well though halting can be sometimes a bit trying. It is possible that as bbradley mentions, that r590 or greater might work - I read the short thread that he linked to, but I couldn't tell how completely they had tested it - whether just the halting was fixed or all of it was fixed. Hmm... experimentation ...
Of course, you'd have to make a minor change or two from the config file that is in the source that jonli &mdfirefighter put up,...
this one might work (it is a cut & paste from jonli's mixed with what I am using now)... note the change in the target specifier : from arm926 to feroceon... I left some of the old stuff commented out... and (iirc) bbradley & I (for sure) have both found that it seems fine to leave the two lines #jtag_nsrst_delay 500 & #jtag_ntrst_delay 500 commented out as well. Again though, I haven't tested this config on wiggler so it may need tweeking... bbradley, did I leave anything out?
# daemon config
# use combined on interfaces or targets that can't set TRST/SRST separately
# jtag scan chain
#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
jtag_device 4 0x1 0xf 0xe
# target configuration
# target <type> <endianess> <reset_mode>
# if chain_pos is not zero it seg faults
#target arm926ejs little reset_init 0
target feroceon little reset_init 0
run_and_halt_time 0 30
# flash configuration
# flash bank <driver> <base> <size> <chip_width> <bus_width> [driver_options ...]
flash bank cfi 0xfffc0000 0x00040000 1 1 0 jedec_probe
best of luck to you ...
LS1 (foonas, nfs, Tranmission
print server, Firefly
for my Roku
Various LS-Pros v1,v2 (unbricked w/ serial & jtag)
KuroPro, LS2 & KuroHG (foonas)
Working on davysweather.dyndns.org
lately... => wooohooo!
Unknown command 'wooohooo!' - try 'help'