Would appreciate any advice anybody can give me with this!
I have 2 x LS Pro 500Gb, the hard drive in 1 failed recently so I bought 2 x 2Tb hard drives intending to replace the drives in both units.
I followed the instructions here http://buffalo.nas-central.org/wiki/Upgrade_(or_replace
)_the_existing_LinkStation_hard_drive and used Norton Ghost to copy the 290 Mb first partition and then flash.
I then followed the instructions to boot the unit into EM mode here http://buffalo.nas-central.org/wiki/EM_Mode
by holding down reset for 20 seconds and then fired up LSUpdater from a PC connected by ethernet only to the Linkstation with the PC configured to the IP 192.168.11.1.
The first couple of times I ran LSUpdate it found the LS Pro but then failed to flash it "LS-GL that needs updating wasn't found" - firewall and A/V on the PC switched off - but then it found it (on 192.168.0.150 not the expected 192.168.11.150) and got part way through flashing it before it popped up the same "LS-GL that needs updating wasn't found" error and quit LSUpdate. Now it starts up and after a few seconds starting making a nee-na beeping noise for a minute or so before making a constant beeping until I switch it off. And LSUpdate can no longer find it at all.
Any thoughts please as to what I can do to recover it.