Buffalo NAS-Central Forums

Welcome to the Linkstation Wiki community
It is currently Fri Aug 17, 2018 6:41 am

All times are UTC+01:00

Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: Some basic questions
PostPosted: Sun Jun 21, 2009 12:51 am 

Joined: Sat Jun 13, 2009 7:53 am
Posts: 18
I have some experience with Linux on desktops and servers and I'm trying to get my head around these Buffalo machines. After installing Freelink and poking around I have a few questions:

1. Does Freelink (etch) install its own kernel? I'm now running, which I assume Freelink installed.

2. Should that 2.6.16 kernel have any modules? After installation I had no /lib/modules/

3. Does that kernel have USB support built in? I think it doesn't, since I have no /proc/bus/usb folder.

4. Are there pre-built modules for this kernel somewhere?

Then, a couple of general questions about Buffalo systems:

5. Where are the uboot kernel parameters actually stored? The uboot image itself is in flash memory, correct? Are its default parameters just compiled in, or are they stored elsewhere?

6. Freelink and other distros come with a rootfs image. My guess is that when I installed it via LSUpdater, it simply overwrote the root filesystem on disk with this image? So if I were to re-install, or install a different distro, I would lose what's on my root fs right now?

Thanks in advance for helping me understand these systems better...

Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Powered by phpBB® Forum Software © phpBB Limited