Buffalo NAS-Central Forums

Welcome to the Linkstation Wiki community
It is currently Thu Jul 24, 2014 11:59 pm

All times are UTC [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Mon May 17, 2010 7:51 am 
Offline
Total Newbie

Joined: Mon May 17, 2010 7:42 am
Posts: 1
Hello,

I have a new Linkstation Duo (2 x 1.0 T)and I like to setup a raid array 1. By default raid 0 is set. I deleted the raid0 and summarized both harddrives with array 1. Console window looks good, no messages. I cant connect to the drive:

* "Map remote default share to drive letter" results in failed mapping, remote default share is missing
* searching in the network environment of windows shows the device but no shares to connect (I setup a folder "share" on array1)

I resetted the drive to delivery status (whichs results in a two day formatting of the drives). After that I could connect to the drives. After setting up a new raid1 array. Same result than above.

How can help
Andy


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: oxygen8 and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:

Protected by Anti-Spam ACP
Protected by Anti-Spam ACP Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group